| Cutting capacity at 90° | Round 255 mm. Square 230 mm. Rectangular 300x180mm |
| Cutting capacity at 45° right | Round 210 mm. Square 190 mm. Rectangular 200x180mm |
| Cutting capacity at 45° left | Round 180 mm. Square 160 mm. Rectangular 180x100mm |
| Cutting capacity at 60° left | Round 135 mm. Square 110 mm. Rectangular 130x100mm |
| Maximum capacity for full materials | Round 150 mm. Square 150 mm. Rectangular 150x150mm |
| Blade size. | 2765x27x0,9 |
| End-cutting bandsaw inclination | 3° |
| Blade motor | 1,5/1,8 kw |
| Blade speed | 35/70 15÷110 m/min |
| Hydraulic unit motor power | kw 0,37 |
| Hydraulic united tank | Lt 12 |
| Coolant tank | Lt 20 |
| Size | 1230x1700x1750 mm |
| Working table height | 940 mm |
| Weight | 412kg |
Wide working area
BS 300 PLUS is equipped with a wide diameter working area and a system of automatic easy stops at 0°, 45° and 60° left and 45° right with graduated plate to identify and set different angles.
Opening vice
The vice has adjustable guides, free to move alongside the worktable, with rapid approaching and camping.
Rigid sawframe
Machine sawframe is rigid cast-iron with tubolar section, 320 mm pulleys, high blade tension at 1700 kg/cm2 and to avoid an excessive strain on the blade with frontal regulation and microswitch conroller.
Blade protection
A carter protect che blade, allowing to have easy access for maintentance when needed; a system with blade guides with hard pads, additional lateral bearings provides for the perfect allignment of the blade
Autocut
GH version has a 3-mode selector:
Manual cut
Fast approach to the material
Automatic cut with adjustable down-feed rate and stop at cutting ending. The user can move manually the sawframe close to the material, then let the machine makes the cut adjusting only the down-feed rate.
Easy to use
Safe starting through the button on the handle with warning light to inform the use about the correct machine functioning. Coolant-tank and electropump are placed inside the floor stand.
Electronic inverter (Optional)
If required, the electronic inverter for variable blade speed allows the operator via keyboard to adjust the machine to be able to cut a wide range of materials and different sections. The change of speed is via inverter and it does not affect the power of the engine even at low speeds.
Minimal lubrification system (Optional)
It is possible to require , for all Imet machines, the minimal lubrication system , it avoids the dispersion of refrigerant liquid typical in the use of emulsifiable oil, the life of the blade is not in any way affected.
Adapter to synchronize sawframe-roller table (Optional)
Adapter to synchronize the RTP/RTD table with sawframe motion.
Pneumatic vice (Optional)
Pneumatic vice, opening/closing synchronised with the sawframe motion
Laser ray (Optional)
Bi-metal blade
Bi-metal blade 2765x27x0.9 mm
