| PARAMETERS | UNIT | UNIT |
| Operation time | Seconds | 58 (aprox.) |
| Pipe thickness | mm | 1,5 and 2 |
| Lock entrance | mm | Adjustable from 18 to 37 |
| Distance between axis | mm | 85 |
| Motor power | kW / CV | 0,75 / 1 |
| 3 phased tension | 230 / 400 V | |
| Weight | kg | 200 |
Characteristics :
- Normally, one operative has an average time between 30 – 45 minutes to make one whole operation for a casing, handle holes and the lock hole in a square or rectangular pipe. With the PI85 Nargesa the time gets reduced to less than one minute. This is a machine for high production.
- The finish is perfect, with the proper tolerance to place the lock with no need to use a bezel. Thus the assembling time is minimum.
- Many companies that have bought this press for locks PI85, not only for their own use but also to sell the ready-to-be-used pipes to other companies.
- The pipes that can be used with the machine are 35×35, 40×40, 40×50, 40×60, 40×70, 40×80, 50×50, 50×60, 50×70 and 50×80.
- Pipe thickness can be 1,5 mm and 2 mm. No matter the material, it can either punch normal steel, galvanized steel or stainless steel.
- It’s important to bear in mind the casing must be always made in the side of 35, 40 or 50 mm.
- The perforation of the lock hole and the handle could be combined, it means we can punch a pipe with lock and handle on both ends, as we can as well make either the handle or the lock in the other.
- The casing length is adjustable as it is as well the entrance of the lock. It ranges from 18 mm to 37 mm.
- Hydraulic punching system.
- Safety pedal.
- Type of keyhole: Bombin.
- Adjustable casing length.
- PI 85 distance between axis 85 mm.
